Answer:
1. Cutting your fabric.
Start by cutting two identical size pieces of fabric, that are each 29.5 inches long and 21 inches wide. This will create a 20×26 inch pillowcase when finished.
*If you wanted a Queen size pillowcase instead, you would cut two pieces of fabric that are 33.5 inches long and 21 inches wide. And if you wanted a King size pillowcase, you would cut two pieces that are 39.5 inches long and 21 inches wide.
2. Fold fabric, iron, pin, and sew.
Create a seam for the outer edges of the pillowcase by folding over the fabric 3.5 inches (on the long end – where the opening will be). Then iron down the folded part and pin it, to keep it in place. Sew the bottom edge of that fabric to itself. This will create a faux cuff, kind of similar to the look of a french seam.
3. Repeat step 2 with the second piece of fabric.
4. Pin the pieces together and sew.
Then put the right sides of the two fabric pieces together, line up the cuffs that you create in steps 2 and 3. The cuffs side is the opening side of the pillow.
Pin the remaining three sides together with straight pins (be sure to keep the cuffed in open) and sew a straight line around the edges of the aiming three sides of the pillowcase.
5. Flip the pillowcase right side out and it’s ready to use.
Explanation:
sorry kung mahaba
brainliest me please
i hope its help
find cloth and then measure the pillow mark the measurements in the cloth and begin sewing the inside after your done flip it inside out and boom done a pillow case
pa brainliest po need ko
